|
| We are running a CANDCNC esp2 that has been updated by CANDCNC with updated drivers and firmware
They also sent us a miniPC that runs LinuxMINT OS with the software and drivers pre installed. Their install guide is lengthy and slightly dated but overall not too bad to setup and get going if you read it.
They will send you the sheetcam license that is for ver. 7.135 as the newest version is windows only. Tell them you need the licensing if you order a complete package.
Do order the feather touch external driver. Do not waste your time trying to make a mechanical touch off work, the feather touch is the best thing and made a world of difference.
If you have anymore questions DM me and I will I’ll give you my number. | |
|
So I bought a non working plasma table off of Facebook marketplace…
