|
| It’s incredible to me that Trimble tech support has been completely unable to give me any answers regarding how to make my XCN-1050 communicate with my EZ-pilot but after 2 months of continuous asking for support I have gotten nowhere. Posting this in hopes there’s some genius out there that knows more about Trimble than anyone in their tech support apparently does.
Hardware:
-Sam 200 EZ pilot Motor
-XCN-1050
-Nav - 900 guidance controller
Harnesses:
-110549 REV B2 SAM-200 cable
-two of 75834
-110549 REV B2 Nav 900 cable
-110551 Cable Assy, GFX/XCN, Power to display, CAN, 2.5 m
- 67258 power from battery cable
-77282 REV A Cable
with this all connected the display powers up, recognizes the NAV - 900 and all associated unlocks and licenses for EZ-Pilot Pro. however the SAM-200 motor is not recognized by the XCN-1050 display.
How can i get the display to recognize the EZ-Pilot Pro motor? | |
|
Trimble XCN-1050 won’t recognize ez-pilot
