SVS - 1/22/2026 09:20

I’ve shown this before. Started out as a 15’ anhydrous bar and it’s evolved a few times in 30 years.

Has three section valves for a boomless nozzle on right wing tip, right wing, and center plus a ball valve to enable a boomless nozzle on left edge of center section.

Have good control of the boomless nozzle by changing boom elevation and playing the wind properly.

Gives a versatile choice of reach. I use speed & pressure for rate control, just simple plumbing with an Ace hydraulic pump and a pressure relief valve that dumps excess flow back to tank.

I like the capacity and staying out of drift compared to 4 wheeler.