|
| I just wanted to make a post for others trying to find information about converting to an ag leader or other spray controller and maintaining the function of your factory boom switches. All you need to do is connect the two wires that receive power when you flip your boom switch on together and connect the ag leader harness to the receiving side of the switch. So when you flip the switch it sends power/signal to the liquid control module and then the module will run power through the wires you connected together to the boom valve. I scoured the internet and couldn’t find answers to it and just wanted to put something out there for the next guy to save him the hair pulling.
 (IMG_0522 (full).jpeg)
 (IMG_0322 (full).jpeg)
Attachments
----------------
 IMG_0522 (full).jpeg (130KB - 7 downloads)
IMG_0322 (full).jpeg (119KB - 6 downloads)
| |
|
|
Hagie DTS 10, 2100, 284 ag leader conversion
