|
Hennepin, IL | I had these directions saved for a customer. This will set Port D up to export NMEA strings, instead of TSIP. If thats what you want to do, this is probably 80% of what you need. Youll want to set up Port A though instead of D, so instead of right 7x in step 4, I think itll be 4x. Whenever Port A shows up. Then IIRC after you hit enter the last time, youll hit down, and there will be a list of NMEA strings to enable (capitalize) or disable (small letters). Youll want to scroll right and up to enable or down to disable. I believe you should only need GGA and VTG enabled for the OT3. If VTG isnt in that list, youll hit enter so that none of the letters are flashing, then down to the second list of strings and it should be there.
If you want to try using TSIP and just make sure Port C is configured correctly for corrections, I think Digifarm has instructions that walk you through that decent enough. The way I walked you through above and below I know will work.
Connect to tractor
Diagnostics
Right, RDI
Right, right, down
Right x7 to Port D Config, down
Right x1 to where 38k.4 is flashing
Down to where I None shows instead of I TSIP
Right x5 to where O TSIP is flashing
Up x2 to where O NMEA is flashing
Enter
Can disconnect from tractor whenever
These settings will be reverted the next time the receiver reboots on the tractor
| |
|
Ag leader ontrac 3, integra and 372 on rtk
