|
SESD | All 3 of my beacons are labeled 372 or 262/372. I have used one of these beacons for a couple years with this app and a 372 without issues. I'm using a Motorola edge+ 2025, but like mentioned I have been using it with Lance's app so its not a phone issue, but i have not needed to use android location in the past, for what its worth my location settings are cut pretty tight, to many apps wanting to use it, but the app here is allowed. I did in the shop play with it last night using android location and it did move past, kept saying android location updated with long/lat , but of course inside a Morton i had no sats to proceed any further. To cold the next few days to fire it up just to putz around with gps hopefully next week we can fire it up again. I have a custom made adapter cable for the digi3 into the fm750. I verified pins based of schematics found on NAT and other websites. Linking TX to RX each way, power and ground must be correct as it lights up and blinks when BT is connected
I will get some screenshots when its up, as of yesterday trying to use receiver location, i had nmea output set a 38k, GGA 10hz and a few others listed in the linked thread posted above here with no success, also tried 57k. Using a Generic CMR and linking a CMR+ data stream on my ntrip source, also tried Generic RTCM3 with an RTCM3 data stream
Like mentioned prior no digi3 setup even recommends nmea out, they all say set it to off. Is there a different output menu I'm missing? | |
|
FM750, ntrip connection
