I’m wanting to add an remote engage master (1 section) switch to toggle the Direct Command L2 on/off. Have an SC110 with IC1200. Everything functions as it should using the master on the SC110. Wired in an SPDT with common switch into the 12 pin connector stub on the SC110 harness using pins 1, 2, and 3. Pin 2 connected to the common. Switch functions like it should on the diagnostics page (turns black to green). Changed the function in the setup page to the E1 switch for the master and section 1 (just like the master was doing on the default setting). The problem is that when I toggle the switch on a “Liquid Control Disabled- Toggle Master Switch” warning banner appears and doesn’t turn on the section. The little toggle switch icon in the lower right corner does go to green though. Not sure what I’ve got wrong?

(8DD82F1D-4729-49A7-8B1A-769500BAB94E (full).jpeg)

(B619F642-E0C8-4D1F-A73C-8E9EB94BF4C4 (full).jpeg)

(B0FB2252-86DA-4A5A-BCD7-51F2BE1E9B85 (full).jpeg)

(1387C9B5-470E-4C1E-8408-EC13C09CA4C5 (full).jpeg)

8DD82F1D-4729-49A7-8B1A-769500BAB94E (full).jpeg (118KB - 46 downloads)

B619F642-E0C8-4D1F-A73C-8E9EB94BF4C4 (full).jpeg (118KB - 49 downloads)

B0FB2252-86DA-4A5A-BCD7-51F2BE1E9B85 (full).jpeg (144KB - 50 downloads)

1387C9B5-470E-4C1E-8408-EC13C09CA4C5 (full).jpeg (167KB - 53 downloads)