|
Central IL | Yes you can do that.
You will need a PP part number 727060 if you are using your CFX 750 with manual guidance, Ez Steer or an Ez Pilot Classic and it will plug into likely port A on the CFX and you will need to export GPS out of Port A at 38000 baud rate, and 5HZ of GGA, RMC and VTG.
If using Autopilot or Autopilot Motor Driver with a Nav2 of Nav 3, you will need PP part number 725599 and you will plug that into the serial port on the Nav controller harness and export GPS out of Autopilot at the same settings as above.
If Autopilot using a Nav2 or Nav3 on a CNH accuguide ready machine, you will need PP part number 727131 and there is a 12 pin Deutsch connector that you plug into that should be very close to the Nav controller. Export out of Autopilot and same settings as well. | |
|
Trimble and 20/20
