|
South Central Illinois | John Deere 9500.
There are 6 wires between each front to rear bar on the concave.
Running just corn through the machine.
Most always under 20% moisture.
Need to pull some of the wires to increase capacity.
Basically to dump more grain directly onto the sieves instead of the walkers.
Obviously, we can pull half of the wires.
What happens if I,
Pull two, leave two, and pull two?
Then I would have a 3 inch opening next to each bar.
Any suggestions here?
Edited by John Smith 12/10/2025 14:21
| |
|
A question about pulling wires on a John Deere Walker concave.
