|
NESD | Here are the instructions to reset the almanac
Receiver
2630
From the main menu> Message Center (Soft Key B)> Addresses(Soft Key G>Press and hold the Addresses Soft Key for 15 seconds, A âTâ will appear to the left of Soft
Key âAâ > Open the Device Menu> Open ITC.001 for SF3000 or GR6.001 for SF6000> Scroll to Address 180>Open Address 180> Press the enter button, A numeric key pad will open, select #1 and Accept, Press the enter button, the screen will return to the Address list and address 180 will display a #2, the Receiver is in the process of resetting, this will take several minutes to complete and start receiving signal from the satellites.
4600/4640
Main Menu > System > Diagnostic Center > Controllers > Press and hold the controller button for 10 seconds to enter Tech Mode, scroll to ITC.001 for SF3000 or GR6.001 for SF6000> Scroll to Address 180 >tap on this bar, tap on the Zero, this will open a numeric key pad, change the number 0 to 1, then accept, this has cleared the almanac, you can X out now and go to the StarFire page, it may take up to 45 minutes to regain full strength signal, keep powered up until receiver is showing 3D SF1
| |
|
John Deere Starfire 6000 no SF1 signal
