|
Cen Ks | On the links to the Vevor site try clicking on the 1/2 drive. It appears to be the strait style.(just like i have)
I need 15/16 to 1 1/2 double angle crowfoot set.
https://www.vevor.com/wrench-sets-c_12370/vevor-crowfoot-wrench-set-...
This is similar to what I have. Not only are the drive holes the same angle as the jaws, the drive tail is too long. The drive hole clearance to jaw throat should just be enough to ger a breaker bar on.
If these tools are designed for tight work, it would be helpful if the total tool dimensions were kept a small as reasonable without sacrificing strength.(My rant!)
In some situations, the crowfoot will be attached to a long extension to get an angle head ratchet/ breaker bar on it. In situations where large hydraulic hoses run in close proximity to each other in a restricted access area, a set of crowfoots like I described would be great .
Edited by clayball farms 12/6/2025 09:02
| |
|
crowfoot wrenchs
