Posted 11/24/2025 15:47 (#11445767 - in reply to #11445535) Subject: RE: Hick: question about the wire winder from a couple years ago
mercer county, il
I’m not hick, but I made one similar. Out auger is a hex, so we took 3/8 plate and cut 6 strips “about” the same size as the flats on the hex, then cut pieces of tin to lay under them to build in some wiggle room, and tacked it all together on the digger, then pulled it off to finish welding it.
Kinda crude, but it doesn’t see a lot of stress. I think you’d break hi tensile or barb wire before you broke the adapter I made.
Hick: question about the wire winder from a couple years ago
