|
NE Indiana | I’m not talking about turn automation or autopath. What I use is called boundary track or boundary fill. I use it all the time. I guess the headlands are just automatically saved in our boundaries so that’s why they show up under boundary fill. But if I change the track spacing it automatically moves that line to half the width. Doesn’t matter what width was used to record it.
The only thing I did to move that guidance like offset from the boundary is change the track spacing. I didn’t have to create anything new.
Edited by kgbarnett22 11/16/2025 10:00
 (image (full).jpg)
 (image (full).jpg)
Attachments
----------------
 image (full).jpg (126KB - 6 downloads)
image (full).jpg (134KB - 5 downloads)
| |
|
John Deere Boundary Fill
