Near Intersection of I-35 & I-90 Southern Mn. | There are various possibilities. A cable is available from Ag Leader that would allow connection to the Integra display cable that has the mate for the metal connector on your tile plow. The metal portion would be permanently mounted on the rear of the tractor. It would then be quite easy to connect/disconnect when you attach or remove the tile plow. Those ISO connectors are expensive.
If your tractor already has such a connector from the factory then that connector can be repurposed to connect to your Ag Leader display cable. This cable kit is sometimes referred to as a "HiJack kit" since it Hijacks the route that the information takes. Instead of going to your tractor's CAN system, the information is routed to the Ag Leader display.
I use this approach with my Deere 8310R so anything plugged into that connector now goes to the Ag Leader instead of to the tractor's CAN system. Deere's intention is that I would be using a Deere display. The kit consists of the various pieces needed including a terminator so the tractor doesn't complain about not being able to find the connector.
Edited by tedbear 11/12/2025 08:18
|
Console cable for Integra to intellislope?
