|
| I did that several years ago when I set up a 19 knife bar Used a Raven 4000 and a 3 section boom switch w/master. Used one flow meter, one rate meter, and 2 shutoff valves. Just used the Raven on/off vales for NH3. Been about 7 years now and I'm not around the machine anymore, but I do remember it worked very well for longer point rows. I think it took the single flow meter/control vavle a few feet to adjust to 1/2 the bar being shut down, but on those longer strips, it worked great.
AaronSEIA | |
|
Anyone controlling multiple sections with NH3 controller?
