|
Eastern NE KS | Based on my 567:
1. Ensure the actuator will run if jumpered from battery.
2. If yes, remove the actuator connectors from harness and pigtail. Then solder wires together with the same orientation as original.
3. If not and you have string tie on baler:
Swap actuator motors on each actuator. Can't recall if I reinstall the now dead motored string actuator but I think I did
I burned up the original 567 net actuator motor with the poor connection that I removed. I soldered the wires hoping for the best connection. When swapping motors, I had an assistant help me hold and align stuff.
I now have a 569 baler 18k bales and no actuator issues. So maybe JD changed something from the 567 model.
Edited by Doug61 10/25/2025 19:37
| |
|
JD 458 baler
