|
Coles County, Illinois | Here's what the book says (clear as mud):
Boom Sense Interface Installation
A boom sense adapter (P/N 115-0171-871 or 115-0171-976) will be required
to toggle coverage history, or “painting,” on or off based upon a machine or
implement switch during a field operation. Once installed, Review the Switch
settings in the System section on page 18 and select the Hardware option to
enable the Cruizer II to reference the switch status for coverage history. To
install the boom sense adapter (P/N 115-0171-976):
1. Connect the 8-pin Turck connection to port A on the back of the Cruizer II.
2. Route a source of 12 volt power to the spade connection on the adapter
controlled by a switch to toggle the signal.
When 12 volts is detected on this line, Cruizer will toggle the coverage history
on and map to “paint” active coverage.
To install the steering interface with
sense adapter (P/N 115-0171-871):
1. Connect the 8-pin Turck connection to port A on the back of the Cruizer II.
2. Route the switch signal to the grey spade terminal on the interface cable.
If tapping into an existing switch, only the signal connection is required.
When 12 volts is detected on this line, Cruizer will toggle the coverage
history on the map to “paint” active coverage.
3. If installing a separate switch specifically for the Cruizer coverage history,
route connect the orange lead to the switch
Cruizer will supply voltage to the switch. When the switch is closed, signal
will return to the Cruizer to toggle coverage history on the map to “paint”
active coverage.
Edited by Herbie56 10/19/2025 21:49
| |
|
Raven Cruizer 2 Weather Resistant. Cable
