|
| Hi, I have a new to me 30ft harvestmore flex header and I’m cutting beans. I can’t get it to cut shorter than 3 inches.
When the head is raised, are the stopper bolt at back of each flex pivot should touch the frame? I see marks like they touched in the past but they have like 3/4" space now.
Looks like the flex could go lower but not sure how to do it.
Those heads are supposed to have good flex but right now I can barely get the outside hedge to touch the ground when I put a 2" block under the middle of the cutter bar.
I’m coming from an old NH flex header and the final cutting job is not even close to the old NH
Edited by JohnFarmer 10/11/2025 18:35
| |
|
Harvestmore grain head adjustment
