|
Northern Ks | The speed and tilt is one harness on right side, tilt has rod and linkage to a box behind upper front faceplate. The wires from it go down to front lower shaft where a magnet and wheel are used for speed, harness then runs along lower outside housing then loop up at feederhouse pivot point about a foot to a single connector. Feederhouse position sensor is mounted on combine by left feederhouse pivot point with a rod and linkage uses 2 bolt to housing, harness starts at sensor all on combine and merges with light under cab, feed acc speed etc. | |
|
S660 Feederhouse Sensors-Erratic Readings
