Southeast Nebraska | aquafarmer - 10/4/2025 11:58
out of the pump put gauge valve and a hose to reservoir let pump run with valve open till you get a clear stream of oil going to revisor slowly start closing valve to see if pump will develop 3200 psi if so inspect rv2 cartridge for debris
Thank you i plan to do that once i have a couple more needed pieces to do so, I have contemplated there could be an issue with RV 1 such that around 2200 psi it just starts sending oil back to the pump inlet vs to the motors. I am mystified by the sequencing valve, i am not sure what sort of magic is supposed to be happening there. I pulled all the valves out but RV 1 and 3 and did a quick visual and saw nothing unusual. |
Question for the Hydraulic Schematic Experts
