|
Missaukee Mi | Low speed is easy because the bar comes down and the pin goes in in just fine. When switching to highspeed, there is the recessed portion on the first disc which would allow the pin to go into the next section. It doesn't line up with the hole on the backside very well and the pin hits the corner of the higher part making it difficult to get in and out. Is there a way to get it line up better? Do I have to take the nut off and realign the parts? Hopefully the pictures help explain my issue
 (IMG_20251004_045251069 (full).jpg)
 (IMG_20251004_050023254 (full).jpg)
Attachments
----------------
 IMG_20251004_045251069 (full).jpg (128KB - 4 downloads)
IMG_20251004_050023254 (full).jpg (138KB - 3 downloads)
| |
|
JD 9500 cylinder Hi/low speed selection not lining up.
