Near Intersection of I-35 & I-90 Southern Mn. | tlf - 9/28/2025 21:10
Yes they did and yes we change it. Had different people message me about possibly have to pull pin 4 out of the 6 pin connector if I’m get a low voltage error.
I put an Ag Leader system in a 9650 STS. With that combine I did need some type of jumper. I now have a 9770. I did need to go in and change the address to keep the Deere system from complaining about not finding the Deere yield components that I had removed.
I do not recall needing to do anything about the clean drain elevator sensor though. My Ag Leader "Y" cable is just plugged in between the original sensor and the original Deere combine sensor. I did this install several years ago and I don't remember if I needed to change anything in the setup.
I do vaguely remember that in some installs (not sure of the combine) that a change in channels was required.
So with the "Y" cable installed does the Ag Leader show elevator speed? At full throttle my Ag Leader shows around 400 RPM which is pretty standard for most combines. Elevator speed must register for the system to work. Possibly changing the elevator speed sensor on the left end of the clean grain auger will show elevator speed on the Ag Leader and not cause the alarm on the Deere side. The Ag Leader Y cable must go in between the sensor and the Deere wiring. |
John Deere 9770
