|
| I’m trying to set up an FJDynamics AS2 autopilot on a Case Steiger 420 tractor, but I’m running into a problem.
I connect the AS2 to the tractor’s CAN bus connector.
The AS2 successfully detects the system.
However, when I press “Start Auto Driving” on the AS2 terminal, the tractor’s terminal immediately shows an error.
On the AS2 terminal, the driving status switches to On road, even if Off road button is switched.
Has anyone experienced this issue with the Case Steiger series? Could it be related to CAN bus compatibility, software settings, or something that needs to be enabled/disabled in the tractor?
Edited by Yulay 9/29/2025 06:48
 (CAN (full).jpg)
Attachments
----------------
 CAN (full).jpg (210KB - 21 downloads)
| |
|
Case Steiger 420 blocked my autosteering system
