|
Holland, Indiana (SW IN) | First and very important get your main in deep enough
Then plow right over the main easiest if about 2” higher than the main
Drill hole at about 45 degrees from vertical snap in tap tee
We use mostly 3” — ADS hasn’t had long 3” tap tees only works 6” and 8” —- if main is bigger than 8” ADS makes long 4” tap tees we use a 4” then reduce to 3”
Going in high on the main no extra friction from the tap tee
If very large main a 3” or 4” internal coupler works just fine
Dan | |
|
For guys that install tile
