|
Ohio | I see you took the 3 bolts out of the one bearing flanges. take the bolts out of the other bearing flange, then you should be able to spread the gears apart enough to pull the gear off the shaft. since the auger shaft is broke you can also cut the auger shaft close to the bearing to give it more slop and pull the gear, bearing and whats left of the shaft out the angle tube. every thing will be rusty and frozen and may require cutting or breaking the bearings to remove. Upon assembly place the gears where they need to be and insert the shafts into the bearings and then the gears. There is nothing that holds the square key in, so make it a tight fit or I shorten the key enough to be below the gear and then peen the gear keyslot in enough with a punch and hammer to hold the key in, or it will fall out later.
. | |
|
In trouble here
