|
NEMO | I bet there's a 100 guys on here that have run those Artsway mills. Here's betting not a single one has ever done that****. It looks like the feed you're trying to stuff through is too wet/stiff. If I'm thinking correctly, you have to drive the shaft out of the gear, kind of have to start out on the end and work your way in one step at a time. That can be fixed, but it's going to take a lot more time than you think. If you come home to MO, I have 2 parts machines sitting inside
Edited by oldtiger 8/3/2025 17:54
| |
|
In trouble here
