|
| Flat on one end with a hole and it's bent around half way to wrap around a pipe towards the front? I was able to get them for my Gleaner head with a Hart Carter cutterbar a few years ago through Agco but I'm certain they weren't 33" long. If you could get enough short ones could you change it over?
Here's the Agco part no just in case you can change it over. Does confirm Gleaner used the short ones
Edited by KFLAgri 7/31/2025 08:52
 (IMG_1739 (full).png)
Attachments
----------------
 IMG_1739 (full).png (55KB - 5 downloads)
| |
|
Hart-Carter or IH Float Springs For Grain Head
