|
MS | I am running Aim Command Flex on a 2250 through the virtual terminal on an Ag Leader IC1200. The sprayer has 500 hrs. I've had very little trouble out of it but running into issues the last day or so. I can run combinations of sections but not all at once. Yesterday starting out it would only let me run one. It could be any one across the boom but as soon as I would turn on more than one it would shut everything down like the master was shut off. Eventually got to where it would run two. Now this morning it will run three and if I turn a fourth on while after the others are running it will stay on but will not turn all four on with the master switch. I've gone through most of the harnessing on the boom and rack, pulling connectors and cleaning even though they all looked good. I've gone through my settings time and time again and shut it down and shut off the battery disconnect for awhile. Has anyone run into something similar or have any ideas. My local tech is a few days out and out of ideas over the phone. | |
|
Aim Command Flex / IC 1200 problems
