|
| Yes the photos are with the kit installed.
I checked with Deere today and the kit is NLA.
You don't really need the kit. All you need is a 3 to 4-ft piece of hyd. hose and some 3/4-in plugs. The filter cover on your 2750 should already be tapped. Take the 3/4-in plug out of the area by the red in the photo. And put it in the area of blue in the photo. Attach hose in the red area of the photo and run it down to the ported filter cover. Find a way to install a plug in the rock shaft cover near the area of the white in the photo. I was not able to get the fitting out and just plugged the hose with a simple pipe plug and hose clamp. This is low pressure and has been that way for 40 years, so it works fine.
Edited by baler brian 7/8/2025 20:51
 (PXL_20250709_012015031 (full).jpg)
 (PXL_20250709_011235382.LONG_EXPOSURE-01.COVER~3 (full).jpg)
 (PXL_20250709_011648106.LONG_EXPOSURE-01.COVER (full).jpg)
Attachments
----------------
 PXL_20250709_012015031 (full).jpg (109KB - 4 downloads)
PXL_20250709_011235382.LONG_EXPOSURE-01.COVER~3 (full).jpg (113KB - 4 downloads)
PXL_20250709_011648106.LONG_EXPOSURE-01.COVER (full).jpg (88KB - 1 downloads)
| |
|
Deere 2750 selective control
