North Central US | jd8850 - 7/7/2025 09:28
I think what you're trying to do is near impossible.
You are trying to use this on multiple trailers. I've never seen a pony motor set up mounted on the truck. It's on the specific trailer. You see them all the time on RGNs
Then any truck can pull that trailer with ease.
A pony motor only has a small volume of oil, not enough for a side dump or end dump.
I'm not sure what you mean by tilt bed. Side dump?
No, just putting it on the trailer.
Tilt deck/bed, similar to this but the axles don't travel. Think what implement dealers had before they went to all lowboys.
 (20171_en_10745_6623_landoll-317-tilted-toload-position (full).jpg)
Attachments
----------------
 20171_en_10745_6623_landoll-317-tilted-toload-position (full).jpg (66KB - 3 downloads)
|
Wet kit/Pony motor setup question
