|
Virginia | Have a contactor that went out due to water getting into the box and/or questionable original wiring. It was 'professionally' wired with the the contactor upside down, power coming in T1/T2, going out L1/L2 and the blue end on the right in the third photo had burnt up and not sure where it was headed.
Just trying to figure out where the wires are supposed to go from the on/off. A1/A2? Our other bin has the off switch going to A1 and the On going to L1, but also has an auxiliary contact used that I don't understand (the new Square D contactor does not have these auxiliary contacts).
Edited by oakhickory 6/30/2025 14:36
 (IMG_8052 (full).jpg)
 (IMG_8056 (full).jpg)
 (IMG_8054 (full).jpg)
Attachments
----------------
 IMG_8052 (full).jpg (91KB - 6 downloads)
IMG_8056 (full).jpg (97KB - 7 downloads)
IMG_8054 (full).jpg (115KB - 7 downloads)
| |
|
Wiring bin unload auger
