|
| Need some help.
I've got a SPX 4420 using an Agleader Insight for steering and product control. We used it a week ago and everything worked fine. We loaded it up with a tank full of product and started spraying. It would not paint, nor would it show a rate or gallons applied. I thought is was the flow meter. RFM 100. We pulled the flow meter and took it apart. Sure enough, the printed circuit board inside the flow meter had some moisture in the cavity it sits in. So, just to make sure that was the problem, I checked voltage on the red power wire and got 5 volts. also checked voltage on the green signal wire and got 5 volts. The black ground wire is working as it should. I reset the Cal number to 1 and tapped the signal wire to the ground wire and got no reeding on the Insight. It is supposed to show a gallon output for each tap, I believe. Contacted Raven and they aren't much help. Contacted Agleader dealer and they haven't been able to help. Then found a Raven 100P flow meter and installed it. Tried it and still no rate or gallons. Any and all help is greatly appreciated. Thanks for your time! | |
|
Agleader Insight and Raven flow meter
