|
Wisconsin | with a hat channel, I think I'd cut a piece of plywood or something that fits the profile you want to bend it to. So maybe a 3-4' wide piece of 1x6 or 3/4" plywood vertically, cut to a radius a little smaller than the actual curve. Then mount it to a kicker, a 2x4 or 6 x8' probably, so you could either hammer the bottom end along the floor, or use a prybar or lever to lift the center of the rib enough to bend it the other way, without lifting in one place and potentially kinking it. | |
|
Enclosed trailer roof rafter repairs
