|
Holly Hill, SC | Pretty common problem for us pulling a 10 row strip till rig in front not planter.
On monitor go to the equipment tab to change the offsets. Under implement 1change the "C" value to compensate for the error. Essentially you are telling your monitor that the implement is offset to the right or left and then the guidance will do the rest.
If the narrow row is to the right (wide row on left) then add an add a value to "C" on the right. If the narrow row is 24" wide and it should be 30" then the "C" value should be 3" (half the error width).
If narrow row is on the left then adjust the "C" on the left.
 (Screenshot_20250622_065939_Photos (full).jpg)
Attachments
----------------
 Screenshot_20250622_065939_Photos (full).jpg (43KB - 4 downloads)
| |
|
Planter End Gaps
