Near Intersection of I-35 & I-90 Southern Mn. | I use the AUX connector on my InCommand 1200 for video. My Ag Leader dealer had a cable that has branches for two cameras and another that has branches for four cameras. I purchased the one for two cameras. It is designed to mate with Cab Cam cameras and cables. Since I use an Overview camera, I needed to purchase an adapter from Dakota Micro. That combination works fine for a rear view camera on our planter and Hagie Sprayer.
I would assume (always dangerous) that these cables would work with the current GO displays also.
One thought might be to purchase the video cables and try to rearrange the pins to the locations needed for your purposes. This might be fairly easy, maybe not. If some type of sealant has been applied after assembly, the rearrangement idea could be difficult or impossible. Even without any sealant, removing installed pins or sockets often requires some type of special tool.
Finding a source for the plugs, pins etc. and building from scratch may be a better plan. One problem is that certain suppliers don't like to deal in small quantities and you may be forced to purchase more than you need. Having a valid wiring diagram would be vital to the success of this project.
Good Luck.
Edited by tedbear 6/21/2025 07:02
|
Whats is connector called
