|
SW MN | I have been out scouting my fields, and it appears that I have a consistent issue with too much of a gap pass and too narrow of a gap on the return pass. What settings would I need to adjust on my 4640 SF6000 w/RTK? Running a 60' planter. The guidance paint lines do not show a gap, and my track line spacing was set at 60'. Spraying is a pain as I have to manually drive or I run over crop, and I am getting some coverage gap in the wide gaps, and overspray in the narrow gaps.
Any suggestions? Of course, you can't "find" this problem until the crop comes out because I didn't think I had a spacing problem. | |
|
Planter End Gaps
