|
SW Iowa | I changed them through the bottom on my 9510. I think I probably had the removable piece (seal I think it's officially called) unbolted from the back of the feeder house floor. They are a pain... fine tooth ratchet or ratcheting wrench probably best as there's limited space for anything to swing.
Second time mine needed replaced, I welded nuts onto the back of the pipe and switched to 50-series wear strips designed to be held by a single bolt that's way easier to access. I'd strongly suggest looking into that option unless you've already procured parts you can't return... then you just need to fight the existing bolts once to get them off.
Edited by Lone Cedar 6/11/2025 10:29
| |
|
1997 JD 9400 Combine Feeder house Chain Wear Strip Replacement
