Near Intersection of I-35 & I-90 Southern Mn. | I did something like that with a CFX-750 that was using autopilot. My system was just using WAAS for correction. This was several years ago.
I was able to get video for a single camera, an implement switch to trigger a coverage map and simulated radar speed OUT for another device. In my case, the appropriate pins were available. I think I went to Port A. This allowed me to use a Raven 440 to control NH3 where the Raven got its speed from the Trimble, the 750 made a Coverage map and the camera helped me hook up the tanks.
My results may not apply to your situation though since you are are using a different display. As I recall one of the wiring charts I consulted was slightly incorrect relating to the video. I believe the chart listed one of the pins incorrectly. I believe I checked another chart that showed the correct location which then did work properly. I haven't used that arrangement for several years now.
Hopefully someone else will reply that has done something similar with a TMX.
Edited by tedbear 6/11/2025 06:14
|
tmx cameras
