|
Central Nebraska | Sections 1-3 would all be in your master module. You can check voltage on both sides of the master module. unplug the weather pack for each section and test the module end of that section's weather pack. Should be 12V on the sockets with the colored wire. The other 2 wires are either black or black w/white. If you do not have power there, there is a bigger weather pack that has a 4-6 wires in it. I don't remember without looking. 3 of those wire colors will match with the colors for the boom sections. Check those on the wire side for 12V. If you have power at that connector and no power coming out of module, your module is probably burned up. If you don't have 12V at this connection the problem is ahead of the AIM modules.
You can check all this sitting the yard with the key on but engine off. Shut your autoswath off and minimum speed to 0.
I had 1 section quit spraying. Did all this diagnostic per my dealer and Capstan and figured out that section was burned up in the module. Sent it off to Capstan and they fixed it. I ran it for a little bit and it quit again. Since it was still under warranty they sent me a new module. | |
|
AIM Command issues
