|
NW Ohio | Having issues getting our Climate FieldView to communicate with our InCommand 1200/GPS 7500. To preface this we had issues earlier in the spring where our FieldView would not communicate with the SCM and found that our Broadcast GPS was not on and fixed this issue or it was coincidence that it fixed this issue. I updated firmware on the InCommand, GPS and SCM before planting corn and now we are back in the same situation. If I unplug the FieldView to InCommand adapter and plug the SCM straight into the InCommand we get GPS signal almost immediately however going through adapter we get no communication from the SCM. I checked all the pins on the cable and seem to be fine. Is there an issue with the newer firmware on the AgLeader? I was hoping someone else could give some input to this issue. | |
|
Climate to InCommand 1200
