northernti - 5/17/2025 16:38 I don’t believe that is correct. We are using the factory CNH accuguide valve with a hybrid cable PN 67120 to PN 75741 to our TMX-2050 and Nav II. There are TAP settings and a cable from CNH to be able to use the autosense with the factory CNH valve, I confirmed with Trimble this morning as we did not use the jumper cable from CNH to do ours but we were still able to make it work. If you're using a TMX, XCN or FMX, in the vehicle profile configuration you can choose autosense instead of the factory steering sensor. The information received from Trimble is below. Autosense on a CNH AGR vehicle Use the AutoSense Steering Device For the CIH Magnum/New Holland T Installation Guide. It says to use The AccuGuide AutoSense jumper cable. When you get it installed you only need to change one TAP setting and the Nav III will adjust the rest. Save the configuration on the display. Also save it to your computer in case the NavController needs to be replaced, or reset. Then you can load the profile that is configured for Autosense.