|
| We have an Intelliview IV/Pro700 and use it w/ Rangepoint RTX (we moved from centerpoint last month because of a dealer miscommunication) with a 372 reviever. We run a bourgault L7550 and use a Topcon X35 with the gps signal going to it over NMEA. The X35 calculates coverage for section control much better because it knows the tow-between configuration and the Pro 700 does not. Is there a software update to make the coverage on the pro 700 more accurate? From what I've seen on New Holland tow betweens they just use implement GPS to solve this problem. If that is the only real solution on this older monitor, is it possible to mix the 372 receiver on the tractor with a 392 reciever on the drill? Asking because if it is we might buy the harness and move a 392 we already have between our combine and the drill. Also, anybody have experience with intelliturn/accuturn? Any good with this older hardware or is it better using a raven GPS and an Intelliview 12/Pro 1200? | |
|
Pro 700 tow-between behaviour.
