|
Holly Hill, SC | Are you hooking up the grain drill to the tractor directly to the ISO plug at the back of the tractor? I never could get my 1990 work this way. I had to use a separate ISO cable and then I thing I used a splitter harness from my receiver to a serial cable to get the speed input on the blockage monitor. I have only used it for one season and will have to see if I took any notes on how I hooked it up. Attached is a link to a post I had on similar subject. I run mine with two 2600 monitors. Guidance and documentation on one and blockage monitor on a second 2600 with just Greenstar Basics. I also want to think you can type in a constant speed to get you by if no speed source is available.
https://talk.newagtalk.com/forums/thread-view.asp?tid=1146884&mid=10... | |
|
Green Star 2600-1990 CCS No speed detected
