|
Holly Hill, SC | I have a 2025 JD 408R with a Gen 5 monitor. A few glitches I have noticed and wondering if anyone is have the same issues.
1. The tread adjust module will not show up on a run screen. Shows up in layout manager but not on the run screen.
2. The auto field locator works about 60% of the time. All my fields have boundaries and if start the machine and it works it will work for the entire start cycle flawlessly. If I start the machine and it does not work then it will not work for that cycle and typically any other start cycles that day.
3. Work setup module will not show on a run screen, similar to the tread adjust.
4. If I press the master switch with the pump off and boom out (boom pressure relief), the map gets painted if I am driving forward. Sometimes it paints and sometimes it doesn't. No pattern. It does not need to paint the field since it is not spraying. Causes issues with swath control on passing over a spot the pressure relief was applied. My old sprayer (4730 with 2600) would never paint the field unless it was spraying. (This would be the correct way of operating)
Software is fully up to date.
Edited by shulerfarm 5/17/2025 10:48
 (Screenshot_20250517_114130_Photos (full).jpg)
 (Screenshot_20250321_134805_Messages (full).jpg)
 (Screenshot_20250321_134815_Messages (full).jpg)
 (Screenshot_20250517_114435_Photos (full).jpg)
Attachments
----------------
 Screenshot_20250517_114130_Photos (full).jpg (66KB - 61 downloads)
Screenshot_20250321_134805_Messages (full).jpg (55KB - 67 downloads)
Screenshot_20250321_134815_Messages (full).jpg (48KB - 68 downloads)
Screenshot_20250517_114435_Photos (full).jpg (62KB - 67 downloads)
| |
|
Gen 5 monitor glitches? John Deere 408R
