|
| Just make sure to put 10gal under the system tab and flowmeter units. It defaults to gal but it needs to be on 10gal for it to work properly with the Deere rate controller. The control valve cal number is typically 2123 and you put that in on the same setup page. You need to perform a catch test as well to make sure the flowmeter cal is correct with your orfices. There are a couple of other tests you can do to check to make sure valves are all working. Good luck but they're fairly simple once you get to using them. | |
|
2630 with Jd rate controller for spraying
