|
Nebraska | Where the cutting roll kicks the silage back to the auger the plate is wore through. I don't have a recutter or corn processor.
Does anybody make a panel that will bolt onto this location? Its welded on the frame, so its not a wear part replacement panel that I can get through JD.
Was just checking to see if anybody knew of either a steel or teflon panel that is made for this. Otherwise I'll have to make something myself to put there.
Looked on Kooima and didn't see anything there.
 (Screenshot 2025-05-14 122620 (full).png)
Attachments
----------------
 Screenshot 2025-05-14 122620 (full).png (72KB - 1 downloads)
| |
|
JD 3975 chopper wore out plate under cutting roller
