|
NE SD | Planter is a White 9816, monitor Incommand 1200.
Everything worked great throughout corn planting, but I started having issues 5 acres into beans. I can go out and unplug and plug back in, which eventually works. I may go half a round or 30 minutes (usually half a round), and all the alarms, messages,and alerts start again. So I go unplug and plug five or 6 times and start the process over again.
I’ve replaced the tractor side connector which worked for a short time, so probably not that. Can anybody point me in a general direction to look? The techs I talked to over the phone (too busy to come out for a peon) didn’t have any guesses off the top of their head.
Here are the messages that pop up every time, there are a couple others that make an appearance occasionally. I did get one that briefly said something like ISOBUS does not match current configuration or something like that.
 (IMG_8932 (full).jpeg)
 (IMG_8929 (full).jpeg)
 (IMG_8931 (full).jpeg)
Attachments
----------------
 IMG_8932 (full).jpeg (84KB - 8 downloads)
IMG_8929 (full).jpeg (84KB - 9 downloads)
IMG_8931 (full).jpeg (84KB - 9 downloads)
| |
|
Planter problem or ISO issues
