|
coast of Maine | Did it freeze? Spin top off, clean cylinder with a rag, check seal for cracks on flange, see if it when manually cycled that the valves close, look like small mushrooms, if froze they brake, put top back on and fill with water, bleed top screw, then check check valve in the suck tube , it looks like a spring from an old ball point pen, be sure it seats in that funky flat o ring. The rebuild kit is not cheap but will get you going if o rings bad , I once smoothed out the inside of the top with steel wool and gave it a tad of Vaseline, got me by, I have a few of these but stationary for fert and chems In pack house and greenhouses ,, they are nice til they don’t suck,, hehehe | |
|
Can’t get dosatron to click
