|
| I have a raven 440 in a new to me sprayer I bought..so it’s needed work and wires where chewed on by micro fixed everything and powered up console and when I went to do the initial setup the us choose worked then whenever I do the sp1 or sp2 I press enter and it doesn’t allow me to put valve type in it just shows .0 on the data display and blinking cal in rate display.i should mention i dont have speed sensor hooked up because the magnetic wheel speed sensor is no good so i want to run my ag express gvs sensor but at the moment i dont have the cable convert from 3 to 4 pin before i buy the conversion cable and go any further i wanted to make sure raven 440 was ok because I believe it was sitting for awhile before i got it..so would not having the speed sensor plugged in cause it not to go any further on initial setup? | |
|
Raven 440
