|
Southern Middle TN | Having an issue with my 7200. I was always told that the parallel arms need to be pretty level to plant. Mine have a pretty decent angle to them. I have taken the spacer of the cylinder and rephrased them, didn't seem to do much. I could lower the planter down, and bleed the fluid off the lift cylinders and it would look good. Then once I raised it up and lowered it back down it would go back to the original spot. Any ideas? It has yetter down pressure springs that work good if I can get it low enough. On my CCS 1790 I have to hold constant down pressure down on the planter. Wouldn't think this 7200 would be the same as it is a box planter but just trying to think of something? TIA | |
|
JD 7200 not lowering in plant
